- SyncBASE Large real-time database
- SyncPlant Intelligent Management and Control System
- Manufacturing Execution System (MES)
- Intelligent simulation and training system
- Intelligent equipment diagnosis and early warning system
- SyncRTLS intelligent safety production management system
- Intelligent fuel management information system
- Intelligent operation optimization system
- Chemical enterprise safety production information management platform
- Intelligent decision center
Intelligent maintenance and training system
Relying on 3D modeling technology and virtual reality technology, high-precision 3D models of typical equipment are produced. On the basis of high-precision 3D equipment model, a vivid and vivid 3D interactive training courseware is produced. Through structural splitting or cutting of the 3D equipment model, the structural composition of the equipment and the name of each component are dynamically demonstrated and explained. Simulate the operating state of the equipment during normal operation, and dynamically demonstrate the working principle of the equipment. By setting abnormal and dangerous conditions, training and guiding personnel to take correct handling measures when dealing with accidents or early warnings. In this way, the basic information, structure, working principle, standard operation and fault analysis of the equipment can be visually trained to improve the technical level of the training personnel.
Features
Operation training function: from cold state, warm state, hot state to full load start-up operation; Unit from full load normal shutdown to hot standby or cold shutdown state; Other operations of starting, stopping, or lifting or lowering load under any specified working conditions; Operators conduct reliability tests and interlock protection tests on equipment or systems.
Fault simulation training function: the simulation function simulates various abnormal phenomena and faults in the real-time operation of the power plant, and reflects the correct results and protection actions; For all kinds of faults and accidents, students can handle the operation at the operator station; F Simulate and analyze fault phenomena and make anti-accident handling plans.
Students' performance evaluation function: set evaluation questions according to needs, and automatically score according to students' operation; It is used for the evaluation of the effect of the practical operation of the post and the assessment basis of the post assignment and transfer.
Thermal training and control logic verification: the control system configuration can be carried out in the DCS engineer station of the simulation system. The interface, operation mode and function of the engineer station are exactly the same as that of the real unit; Verify the effect of control system configuration change on unit operation.
Operation analysis function: calculate and compare the thermal economic indicators of the units under different working conditions and different operating modes, and optimize the start, stop and operation of the units. By viewing the logic, you can master the control mechanism of the device and operate the device reasonably and skillfully.
Equipment maintenance training: make vivid and vivid three-dimensional interactive training courseware; Realize the three-dimensional visual training of equipment basic information, structure composition, working principle, standard operation and so on.
Contact service team
-
Contact：Mr. Liu Minghao -
Contact number：+86 13626102243 -
Mailbox：liumh@jnyunjian.com
